Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
IFW 2019 - Section of alignment disappears when adding a bridge
IFW 2019 - Section of alignment disappears when adding a bridge
Hi,
just installed infraworks 2019 - i'm using a model slightly less than 200sq km, 22km alignment across this. Most of the alignment is elevated. So I import alignment (with vertical profile) from Civil 3d. Then try to place a bridge along the alignment. Everything working normally until model regenerates and section of alignment has disappeared.
Attached image shows red dashed line approximately where the alignment runs, blue dashed line approximate extent of bridge placed. Infraworks 2018 on separate computer - no issues.
No regen doesn't fix.. Tried all manner of things.. completely redone several versions of this alignment using Civil 3d DWG imported instead of imported IMX alignment.
It seems to be linked with tiles. When I turn on tiles, extent of alignment covered by tile is not showing. When I turn off tiles, entire alignment disappears.
