Acramatic 850sx

[Anonymous]

Hello Autodesk. I have a Cincinnati vmc with an acramatic 850sx for the control. The acramatic post you currently have will not work for my Machine. Can you guys either help me create a new post for this machine or create one on your end? I need this machine running. I am a one man operation and do not have the funds to buy any other cam software. Please let me know if you guys can help me.

Thank you
-Dillon

[Anonymous]

I'm actually working on getting set up with a post processor for this same machine/controller to do some subcontract design and programming work.  I've found a post that was modified to some extent, but it appears still needs a few changes.  Here is the thread:

https://forums.autodesk.com/t5/hsm-post-processor-forum/editing-cps-files/td-p/6071633

I can post a few simple programs, send them over to him, and have him report on the behavior.  I've also found some information on the Mastercam forums on how the drill cycle logic works, (or doesn't LOL) and how it uses incremental commands from a reference plane for drill cycles.

Here:

https://www.emastercam.com/forums/topic/9591-help-with-acramatic-850-drilling-cycles/

[will_1]

Hi,

This post processor is in development and can be found here. If you have feedback please provide it.

https://cam.autodesk.com/hsmposts?p=acramatic_850sx_turning

Thanks,

Will

[Anonymous]

Does this post work? Sorry had been sidetracked lately and am still wondering if I can use fusion to talk to my Sabre. Thank you!

[Anonymous]

Looks to me that the post provided above is for turning. I am needing one for milling.

[will_1]

Hi @Anonymous ,

This one should be for milling. (see link below)

https://cam.autodesk.com/hsmposts?p=acramatic

Thanks,

Will