WinPC-NC USB post processor error

[nmd2407]

Good day,

I tried today to use the dedicated WinPC-NC post-processor in order to use the 4th axis on my machine and I get the error attached to the pic. So far I have been using the generic RS-274D post-processor for all my other 2D-3D OP and I haven't had any issues

[AchimN]

This might be the same issue as in this topic:
https://forums.autodesk.com/t5/hsm-post-processor-forum/error-failed-to-evaluate-post-configuration/...

[nmd2407 · Accepted solution]

Good evening

I just checked the forum link you've attached and after minor research, it seems indeed that was my issue when i went to an older version of the post-processor the G-code posted normally... Will need to confirm everything with the machine tomorrow.

Thanks again for the help