mazak integrex 5 axis post

[Anonymous]

i am using generic mazak post processor for I 400 integrex single spindle single turret. i have edited where i get correct indexing but full simultaneous 5 axis doesnt move quite right. also prefer just indexing B C then  using just G68 not G68.2. thank you.

[will_1]

Hi @Anonymous ,

What post processor are you using? It is hard to say what is going wrong with the simultaneous moves without more information. More than likely on a Mazak it is a parameter setting. You can reach out to your Mazak rep for more information on that. I will send you our suggested ones as well.

On the G68.2/G68 Mazak recommends that you use G68.2 because there are functions are available in G68.2 that are not available in G68, like G05 P# if I am not mistaken.

Thanks,

Will