Some how I nave modified Fusion such that Y now points up instead of Z. I think I did this once before and found the solution, but can not remember what I had to do. Can someone guide this dummy out of the forest? See attached cube pic.
@crchisholm Go into Preference - General - Default modeling orientation and you can make the selection there.
Rajkumar Ilanchelian
Autodesk Fusion
Join Fusion Insider
Please do not double post. This same question was asked in the Design, Validate and Document Forum which was answered there also.
John Hackney, Retired
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Can't find what you're looking for? Ask the community or share your knowledge.