Hello All,
I am struggling to understand why I can't patch the end of these surfaces. For whatever reason it wont let me select the profile in patch/loft but will in sweep?
Thanks in advance
Will
Solved! Go to Solution.
Solved by williampj.metal. Go to Solution.
Solved by HughesTooling. Go to Solution.
Not sure if the problem was you had several edges and a sketch making it hard to make selections.
I hid the sketch and one of the surfaces that seemed like a duplicate, then stitched the other 2 surfaces. This makes the selection a lot easier.
See attached file patched and stitched into a solid.
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Thankyou HughesTooling.. in retrospect very simple but has been frustrating me for hours!
Can't find what you're looking for? Ask the community or share your knowledge.