Switching Between Configurations Bug

[20017182]

While trying to implement configurations in my assembly, I tested switching configurations, and it didn't change any of the parts. I was using configured parameters to adjust angles and distances in 'pin-slot' and 'revolute' joints. I had two configs, one had the parameters set to 0, and the other had them set to the required angle/distances. When I switch between the configs, no changes are made. When I check the joints, they weren't set to the parameters (despite setting them to said parameter(s)), instead the joints were set to the value of the configuration I switched from.

Config 1: just after I set the joint to the configured parameter (-3.825")

(not letting me upload other screenshoots)

Config 2: assembly/joint remained in the same position, until i enter the joint and re-enter the parameter

Switch back to config 1: Joint is now set to 0in (the value of config 2 parameter) instead of the parameter

[mayank.malukani]

Hi @20017182 , Thank you for reaching out, I wanted to understand a bit more about what exactly was configured. Was it the the offset values of the pin slot joint?

[TrippyLighting]

This is impossible to troubleshot without the design.

If you can share it, please export it as a .f3z or .f3d and attach it to a post.

[lauri_barnhart]

Hi @20017182,

I wanted to check in and see if you saw @mayank.malukani and @TrippyLighting's follow up questions and you still needed assistance, or if you found a solution to your question already? Please share any available screenshots or screen recordings so the community can assist you further.

All the best,

Lauri | Community Manager