Lead in and Lead out

[Anonymous]

Hi im new to fusion 360 and I have been having trouble on lead in and lead out. Im using a cnc plasma table and the lead in and out are on the actual piece to cut. Am I able to disable this with out a problem or am I able to edit the pierce points?

[carl.j.barker · Accepted solution]

When you create or edit the toolpath you should see red arrows, clicking one will change which side of the line should be cut and have lead-ins.

[Anonymous]

Thanks man that helps out a lot.

[HughesTooling]

---

@Anonymous wrote:

Hi im new to fusion 360 and I have been having trouble on lead in and lead out. Im using a cnc plasma table and the lead in and out are on the actual piece to cut. Am I able to disable this with out a problem or am I able to edit the pierce points?

---

I'd guess you are only using a 2d sketch, if you extrude and create a body Fusion will usually offset to the correct side automatically. 

Mark