Haas Chip Clean (E...) in drilling codes

[Matthew.Magnaghi]

Hello,

I work in a shop with Haas VF2ss and VF4ss.  They have the ability to reverse the spindle in between drilling holes with the E command.  I'm not very fluent with editing Post Processor Codes, and trying to figure out how to enable that function to true.  Or am I missing something more basic, in the post parameters to force this function?

I would actually like to just have it forced to chip clean after every hole, without having to toggle a switch every time I create a new hole pattern.  

Any help would be appreciated.  thanks-MJM

[boopathi.sivakumar · Accepted solution]

Hi @Matthew.Magnaghi 

you can add a action command "CYCLE_REVERSAL"  before the toolpath that should get you the code

[Matthew.Magnaghi]

That did the trick.  Thank you, still new to this Fusion 360, learning new tricks every day.