Fusion getting sluggish and Edge Crashes

[ssashton]

I just wanted to see if anyone else has noticed Fusion getting sluggish since about the last month and that having fusion open sometimes causes MS Edge to crash?

Or is it a 'me' problem?

I'm not talking about complex projects, even simple ones. I especially notice a short delay when panning, but also longer than typical delays when doing simple operations such as extrude, or editing sketches. Just generally laggy, which it was not a few months ago, so it can not be a hardware issue.

I am running Windows 10, perhaps Fusion is now being optimised for Win 11?

[TrippyLighting · Accepted solution]

---

Fusion is now being optimised for Win 11?

---

I would update to Windows 11 for reasons somewhat explained here.

[ssashton]

I might be wrong, but I would swear I had updates to Fusion after March on Win 10. It is around then it started going sluggish, lol.

I installed Win 11 and so far so good, I think.

Sadly my audio interface does not support Win 11 😞