Talk shop with the Fusion (formerly Fusion 360) Manufacture Community. Share tool strategies, tips, get advice and solve problems together with the best minds in the industry.
Talk shop with the Fusion (formerly Fusion 360) Manufacture Community. Share tool strategies, tips, get advice and solve problems together with the best minds in the industry.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Hi, I use near left corner on my 4'x4' cnc bed. I would like to use dead center or 24'' x 24''. do i just set up mill at middle and post process as normal? I question that code will run negative and wonder if this matters.
When you create a new setup. Under stock. You get to select the origin. Ie where the machine needs to be centered. Pick a stock box point or a model point. If it is top center then fusion will figure it all out
