The surface measurement results are output as follows.
The Z value is output including the probe radius value.
Is it possible to output the Z value without including the probe radius value?
G330 N1 A+0 B+0 C+0 X0 Y0 Z0 I0 R0
CALIBRATED RADIUS 1.924ECCENTRICITY X -0.003ECCENTRICITY Y -0.001
G800 N1 X-19.588 Y-5.871 Z+0 I0. J0. K1. O+0 U+0.1 L-0.1
G801 N1 X-19.588 Y-5.871 Z1.960 R1.924
G800 N2 X-6.791 Y+6.923 Z+0 I0. J0. K1. O+0 U+0.1 L-0.1
G801 N2 X-6.791 Y6.923 Z1.960 R1.924
G800 N3 X+16.783 Y-5.471 Z+0 I0. J0. K1. O+0 U+0.1 L-0.1
G801 N3 X16.783 Y-5.471 Z1.961 R1.924
END
Fusion
