Stock model turns black as zoom in

[mattdlr89]

My green stock models turns black as I zoom into it and is unusable. 
Is this down to settings or hardware issue? 

I've attached a few screenshots as I zoom in. It has always done this in my limited time of using Fusion 360 (a couple of weeks). Although today it seems to be going black at a lower zoom level than previously. A little frustrating when trying to inspect the stock model.

Hope someone can help.

Thanks

[seth.madore · Accepted solution]

Change to these settings:

2020-07-08_11h35_47.png

2020-07-08_11h35_35.png

This is a long standing lighting issue. Using the settings above will greatly eliminate that

  

[mattdlr89]

Hi Seth

Thanks for your quick response. I made the changes it didn't have any affect until I restarted Fusion.

All seems to be good now I can zoom in further than I'd ever need to without the model going black. 

[DarthBane55]

@seth.madore 

Seth, is that a fix for the %$#@$ easter egg?

[seth.madore]

No, we're stuck with that 😉

[DarthBane55]

😓

[martin.konarsky]

I have chenged settings of Fusion, but it did not help. I am totaly disapointed and frustrated.

Does anybody have finaly solution?

Please have a look on videa attached.

thanks a lot

[martin.konarsky]

Hello all,

I have found solution when this happens.

It works for me, please try if it does work also for you.

When the model turns black I have to change the camera from orthographic to perspective and then back.

When the model is reloaded (regenerated) the problem disappears.

Of course, this is not a solution, but it helps. I believe, that Autodesk team will solve the problem, sooner or later.

best regards