Second pass with offset - finishing strategy

[dan3s2020]

Hi ! I want to make a parallel strategy on a model and  be able to make a second pass with the same strategy but with an offset for the stepover in case i'm not satisfied with the result , to run this second pass to go over the scallops ,like starting with an offset of 0.5mm from the edge of the model. Is it possible?

*A few more  noob questions about feeds & speeds if it's allowed: 
It's too fast to plunge with ~250mm/min and cut with 700mm/min feedrate in oak with a r0.25 tapered ball nose?

any advice for the rpm?

[engineguy · Accepted solution]

@dan3s2020 

Have you tried just using the "Additional Offset" under the "Geometry" tab set to 0.5 ??

That will make Fusion create the toolpath offset by the 0.5, may bo what you need, just a crude "workaround" 🙂

[dan3s2020]

oh, that really is a workaround .Thank you !