Re: Router Bit Travel Speed

williamlFL · ‎10-25-2016

Hello All,

How can I adjust the rate of speed when the bit is out of the material?

-Will

LibertyMachine · ‎10-25-2016

When it's out of the material, it should be feeding at G0 speed which is full rapid. Of course, that may vary depending on what your selections are as well as what post processor and machine you are using

Seth Madore
Owner, Liberty Machine, Inc.
Good. Fast. Cheap. Pick two.

williamlFL · ‎10-25-2016

Thanks Seth.

xander.luciano · ‎10-28-2016

There's also this setting you can mess around with if you're daring.

But like Seth said, mostly it's just the machine rapid between movements.

Best,

-Xander Luciano

Xander Luciano
CAM Content Developer

If my post is helpful, press the

Kudo button - If it resolves your issue, press Accept as Solution!
Quick Tips: When to resselect CAM geometry | Understanding Smoothing in CAM | Adaptive Facing | Online GCode Viewer

Fusion

Router Bit Travel Speed

Router Bit Travel Speed

Forums Links

Post to forums