Post falure cant find log either

[safiredesignengineers]

hi group

every time i try to post the parting off cycle i get a "post failure" written on the end of the cam file and looking at the gcode it says see log but i cant find the log anywhere on the pc?

please advise

[HughesTooling]

Fusion tends to delete the log before the editor can start, try starting the editor before you post or change the editor to notepad as it starts faster.

Mark

[HughesTooling]

Are you using the ProtoTrak post? If you are the problem is the Turret number for your last tool.

Mark

[safiredesignengineers · Accepted solution]

Hi Mark

I have fixed it i think, just checking now but it was to do with the tool.  i copied a tool from the tormach range and edited it originally. but i just created one from new and it seems ok. 8-)
thanks for your input.

[HughesTooling · Accepted solution]

Just in case you run into this again all you need to do is edit the tool and change the turret to zero.

Mark

[safiredesignengineers]

thanks mark 🙂