Talk shop with the Fusion (formerly Fusion 360) Manufacture Community. Share tool strategies, tips, get advice and solve problems together with the best minds in the industry.
Talk shop with the Fusion (formerly Fusion 360) Manufacture Community. Share tool strategies, tips, get advice and solve problems together with the best minds in the industry.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Hi everyone, I am having an issue with the generic Mazak mill post. I have my tapping cycles turned on to use feed per revolution and when I create the NC program, I have use pitch for tapping turned on. But when it posts it is saying this post processor does not support feed per rev. Am I doing something wrong or is it the post? If this is a common problem would anyone know what to change in the post?
I am using the Mazak mill post version 44131. The feedrate is correct as far as the pitch but it refuses to insert G95 instead of G94. I know its a simple fix but something this simple should be correct.
I just tried out the code in the machine and to my surprise it seems like the G84 defaults to feed per rev without the G95 present. I used the same code I replied with, and the RPM was 1000 and the FPR .0312. While watching it the active feedrate became F31.2. I didn't know it could do this and since it did, I am not sure why fusion was giving me the alarm that says it can't support it.
