Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Can anyone help change the numbering principle in the post processor? I would like the numbering of the sequences to be assigned through 100.
N100...
...
...
...
N200.
But if the block contained a turning cycle G71, G72, then the numbering of these within the cycles continued like this - R101 Q102 and again N 101....N102.
N100
...
...
G71...
G71P101 Q102...
N101...
...
...
N102
...
...
Following according to the criterion of starting from N200
