Issue recognizing holes

[Anonymous]

I have drilled and tapped hundreds of holes in things modeled in Fusion

I don't know if I'm just over tired, but I can not get the Drill Cycle to recognize a tapped hole.

I can not select the threaded hole by selecting the face nor by using diameter range. I have no issues selecting non-threaded holes

If I go to the Design Workspace and suppress the threads, I can drill the pilot hole, but can not get a tapping toolpath to generate once I Un-suppress the threads. 

I have never had this issue previously- did something just change?

I have a paid subscription, but do not pay for the hole recognition extension.

Thank you

[seth.madore]

You don't need the hole recognition wizard to do this. Can you share your Fusion file?
File > Export > Save to local folder. Return to thread and attach the .f3d file in your reply

[Anonymous]

Thanks for the reply. I was always able to do this before with no issue

I have up loaded my model

Thanks for the help

[seth.madore]

It appears that the edge you selected to align your Z in the WCS is NOT a good edge. Rather, select the face of the part:

Result:

  

[Anonymous · Accepted solution]

Thank you very much. That fixed it. I would have never found that!