Haas Next Gen Post not Outputting a G93 for Swarf Toolpaths

[c0454965]

I am attempting to Output a Swarf Toolpath with Inverse Time Feedrates G93, however even after searching through my Post Processor I can't find where to switch it from G94 to G93. I ran 1 of the Swarf toolpaths and it move far faster then desired and left a terrible finish. I have attached both my post and program, this is a student project I'm working on. Any help will be much appreciated.

[rushikesh_nagalkar · Accepted solution]

Hey, Here's a quick fix that might resolve your issue. you were not able to find the settings for G93 because its linked with Machine definition file. Just the follow the steps as instructed in a attached image. Let me know if it works for you.

[dames123]

Hi Rushikesh,

What's the difference between Inverse time (minutes) and Degrees per minute standard?

Thanks.