Fusion
Community
Hello,
on my small lathe, I do have a rear side tool
https://www.youtube.com/watch?v=fyLjzj8Gads
and in fusion 360, there are normally front side tools and operations.
When I reverse under "setup" the X orientation
the toolpaths are not on the rear side (opposite to the red x arrow).
Only the view is rotated ... it changes nothing.
And when I change the tool orientation here to 180 degree
fusion produces an error
because the tool is rotated, but fusion still choose the front side, so holder and workpiece would collide...
I think I'm missing something important. I would appreciate any help
Best Regards
Simon
Forums Links
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
