2d Chamfer Help

[jscott6SWZG]

I had this working, but not anymore.

Pls see set up; topalu op 2d Chamfer.

I have a countersink bit, that i hope will work for the chamfer.

I have selected various contours...with no luck.

The strange thing is the tool path shows an error 

Warning: Empty toolpath. If you are machining a chamfer that is modelled, try setting the Chamfer Width and Chamfer Clearance to 0

I did that, but when I click generate I get a message

The selected operation has a valid toolpath.

Do you want to generate the operation anyway? I click yes with no luck.

[engineguy · Accepted solution]

@jscott6SWZG 

Try setting the Heights Bottom to the top face and not using the sketch, I turned off the sketch and selected the edge of the Model, works.

Your Countersunk tool works fine, also see the Chamfer width etc settings, hope this helps, see attached file.

[jscott6SWZG]

Yeah that is what i needed.  You showed me the outer edge chamfer, i was working on the countersink.

But the straight edge explained things nicely.  Thank you much