Tool Orientation and Hole Face Selection is Lost when moving Operation to a folder

[alex_winter]

Hello, I believe I noticed a bug. when moving a drilling operation into a folder It is losing the tool orientation and Hole Face selection for that operation.  Here are the steps to reproduce it.

1.  Create a drilling procedure selecting a tool orientation face and Selecting a Hole to drill.

2.  Create a folder in the setup

3.  Move that operation into the folder.

Now when I open up that operation in the folder I have lost my tool orientation and selected Hole for drilling. 

I believe it is only with drilling since I just tried it with 2D contour and it is working correctly.

[Andrew_Todd]

Hi Alex. Are you able to share the Fusion file so I can take a look? Thanks

[alex_winter]

I cant share the file but it seams to be working again which is odd.

I deleted the folder and re-made it now its working again so I am currently trying to re-produce it or figure out why.  

I do have 9 operations that have lost the tool orientation and hole selection though which is un-expected.

Ill get back to you. 

[alex_winter]

Alright I was able to re-produce it again.  What I did was I copied a drilling procedure from an older fusion file.  If I make the same procedure from scratch it is working fine.

I copied it from another fusion file and then modified it to my needs and then duplicated it 9 times which caused all 9 of them losing its tool orientation and selected face.  I guess I have to be more carefull re-using older fusion operations.

[programming2C78B]

It doesnt have any orientation because you copied it from somewhere else. The folder had nothing to do with it. 

[alex_winter]

Yes I copied it from another fusion file and then made a new tool orientation and selection and calculated it.  then I moved it to a newly created folder and then it loses them.

[alex_winter]

Here is the fusion file.  If I copy this procedure into a new fusion file and re-select/make a new tool orientation and hole selection and calculate it.  Then make a new folder and move this procedure into it, thats when I lose the new tool orientation and hole selection.

EDIT: If I instead use "Add to New Folder" it works correctly.  Also noticed if the New Folder (on the tree) is ABOVE the operation.  When I drag it in this works.  If the  New Folder location is at the very bottom of the tree and I am dragging the operation down into it, It doesn't work.   Here is a Video I made