Post process error or intended?

[LibertyMachine]

When posting out any drilling cycle, I get this at the end of the cycle:

G80 M9
Z.05  (this line should not be here)
G53 Z0. M19
M1

The issue I have is with the Z.05 move right after the G80 M9 line. That should not be there. So, if I've got a retract plane of 1" above the part, it will rapid up to that plane, and then right back down to .05" above the part. Haven't had any bad things happen, but it's disconcerting and I'd rather not put that out on the floor.

Furthermore, if I am spot drilling holes of different sizes, how do I get the coolant to persist through the multiple G80 calls?

G43 Z.05 H21 M8 T22
G98 G82 Z-.0466 R.05 P500 F13.1
Y-.2375
G80 M9   (the M9 should not be here)
G0 Z.05   (again, this line should not be here)
M8          (if the M9 can be prevented from being output, then perhaps the M8 won't populate?)
G0 X2.65 Y-.2425
Z.05
G98 G82 Z-.0556 R.05 P500 F13.1
X3.15
G80 M9
Z.05   (again, this should not be here)
G53 Z0. M19
M1

If this is something that can be controlled in the Fusion environment, that would be great. If it requires a post modification, then I will toss it on the CAMforum

[Steinwerks]

Can you share an example part and your post processor here?

[LibertyMachine]

http://a360.co/1TOIPiW

[jeff.walters]

That looks like one of our standard post setups. If it doesn’t work on your machine you can modify it to not out put it. Did you get the post from us?

[LibertyMachine]

It was a standard Fusion post. I edited it as far as I could go quite a while ago and then Laurens-3D did a few things to it, and then someone else, and then even more later on, so on and so forth

[LibertyMachine]

Should I kick this over to the CAMforum for post editing, or are those moves inherent to Fusion?

[jeff.walters · Accepted solution]

yes sir they would be able to help you here

http://forums.autodesk.com/t5/post-processors/bd-p/218

[LibertyMachine]

Thanks again @jeff.walters