mach3 turn threading g76

[Anonymous]

hi i have a lathe run by mach3 turn

the post processors ive tried want to output g code for canned cycle as g78   .. i can produce g32 if i uncheck canned cycle .

i would like g76  canned cycle .

is there anything i can do /buy /change to get this?

regards steve 

[Anonymous]

thanks 

easy when you know how 

[will_1]

Hi @Anonymous ,

Did you have any luck with G76 threading?

Thanks,

Will Watkins

[Anonymous]

not had time to try it as ive put a new motor in the lathe will have a go on the weekend ..

can you help my startup subscription is about to run out . i re applied a week ago . no confirmation email and no contact  can someone check to see if im in the system 

steve