Haas Post processor a axis problem.

[turningHU8CX]

Hi,

We have Haas VF4SS with 4th axis, with our Haas next generation control post processor Fusion wouldn't post process program when "has A-Axis rotary" is set into reversed and C axis is rotatting the wrong way at the moment.

this is what error page says

Any help would be grat !

[AchimN · Accepted solution]

Hi @turningHU8CX ,
it looks like you are trying to postprocess with a machine configuration AND have the "Has A-Axis rotary" property selected at the same time. This results in the conflict that you are trying to post with two machine configurations and it then fails.

You can only use one method, so you either must set your "Has A-Axis rotary" property to "No" or deselect your machine configuration.

[programming2C78B]

The error code says it completely correct.

Also FYI there's a setting on the controller to reverse the A axis if you don't want to mess with it in the Post.

[programming2C78B]

https://www.haascnc.com/service/troubleshooting-and-how-to/how-to/reverse-rotary-direction-setup---n...

[turningHU8CX]

This method worked. Thank you very much