Disrespect from Morph Toolpath?

[ilirmartini]

Morph toolpath refuses to comply and does not machine continuously from left to right. It skips areas then comes back to finish those areas. If I select "both ways" it will machine very nicely from left to right but I am machining a shallow angle and need it to machine "one-way" and "uphill" in which case it skips areas. Has anyone encountered this problem?

I attached the file if anyone is interested. Thank you.

[a.laasW8M6T · Accepted solution]

I very rarely use Morph, In fact I don't think I've ever actually machined a part with it.

I have seen that behavior before when looking at other peoples programs but am not sure why it does it.

May I suggest using Blend Or Geodesic set to Blend mode instead.

I think Blend Gives the best results here

See attached file

[ilirmartini]

You are absolutely correct, Blend is a much more respectful finishing strategy than Morph. It machined from left to right and uphill very efficiently.

Thank you for turning me onto Blend and I greatly appreciate your help!

[oleg.tikhomirov]

Hi @ilirmartini 

Thank you for the feedback. I've created CAM-65216 to investigate and fix the issue in Morph strategy.