Hey guys,
I have issues with the 3D CAM operation parallel. I got this surface from a knife that is beeing milled with this operation. Picture 1 shows the actual tool path from the finsihing path with a fine step over. The path itself is fine but I would like to extend the tool path in both directions a few mm (shown in picture 3 red arrows). I know that there is the option "extention" (picture 2) but when I select it, I got the problem shown in picture 3. I just want that the actual tool path is beeing extented, not changing the diraction.
Is there a solution to my problem?
Thanks in advance.
Jannik from Messerlabor
Gelöst! Gehe zur Lösung
Gelöst von rewedesk. Gehe zur Lösung
Sie finden nicht, was Sie suchen? Fragen Sie die Community oder teilen Sie Ihr Wissen mit anderen.