STL creation not working properly

[Anonymous]

Hi,

I just wanted to share this, don't know if it's only me, but right now, "Create STL" is not working, not even with "3D Print", this is what I get and it didn't do that before.

It's happening with every single file I try to create an STL with, here's with one of the grip component from your utility knife design example:

[Uhlhorn]

The same here!

When I select the root and try to save it as STL with the structure „One file per body“ it fails.

Saving with the structure „One file“ it woks.

When I try to export a body as STL after using the structure setting „One file per body“ it fails.

When I try to export a body as STL after using the structure setting „One file“ it works.

I hope it helps.

[Uhlhorn]

Try to „save as STL“ from the root using the structure setting „One file“. After this You should be able to export bodies as STL.

[jeff_strater · Accepted solution]

See this thread:  new-stl-mesh-level-preview-broken-i-only-see-red-lol.  The problem is just a graphics problem.  As far as we know, the exported STL is still fine.  We are working on delivering a fix

Jeff

[Uhlhorn]

---

jeff.strater schrieb:

As far as we know, the exported STL is still fine.

---

When You choose „Save as STL“ with the option „One file per body“ than STL export fails. Perhaps these are two different issues.

[Anonymous]

Thank you, Jeff, I read that thread later yesterday.