Stitch problem

Stitch problem

HughesTooling
Consultant Consultant
536 Views
3 Replies
Message 1 of 4

Stitch problem

HughesTooling
Consultant
Consultant

Stitch was improved in the last update but it now defaults to a 1.0mm tolerance, this is way to high for anything I work on. Is there a setting to change it to 0.01mm, sooner or later I'll forget to change the setting and a 1.0mm tolerance could cause problems.

Capture4.PNG

Mark

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature


0 Likes
537 Views
3 Replies
Replies (3)
Message 2 of 4

masa.minohara
Alumni
Alumni

Hi Mark,

 

Thank you for posting! I tried to find a way to change the default value but couldn't find one. I'll check with my colleagues and update you as soon as I can.

Masanobu Minohara

Product Support Specialist



Fusion 360 Webinars | Tips and Best Practices | Troubleshooting
0 Likes
Message 3 of 4

masa.minohara
Alumni
Alumni

Hi Mark,

 

I have talked with the development team and found out that it's not possible to change the default value for tolerance in Stitch command, and for now we need to manually change it each time. 

 

I have logged this as an enhancement idea (FUS-28108) with the development, and they will review this.

 

Thank you for pointing this out!

Masanobu Minohara

Product Support Specialist



Fusion 360 Webinars | Tips and Best Practices | Troubleshooting
0 Likes
Message 4 of 4

HughesTooling
Consultant
Consultant

Hi Masanobu

 

It would probably be best if it was set base on the General tolerance setting, so a tolerance setting of 0.12 would set the stitch tolerance to 0.01mm and general tolerance of 0.123 would be 0.001mm etc. I'd rather the stitch fail because the tolerance is too tight than forget to set it and have it use 1.0mmm.

before.png

Mark

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature


0 Likes