In the screencast below I show a couple of problems with the sketcher. The first one is just a problem with the constraint colouring, adding a dimension to a point shows fully constrained but adding the same dimension to a line doesn't. Both should work the same. The second bug caught me out when I moved some dimensions in the sketch to make it easier to see what I was doing, I didn't notice I'd move the angle dimension to a one side so it was no longer measuring the included angle. The file's attached.
Mark
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
