Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
What is the meaning of the red color when the fully constrained profile is selected ? If error, the Sketch Tester indicates "Could not select points""...
You drew a center rectangle first then added a circle mid point try adding tangent constraint on left circle and make sure everything fully constrained. Try drawing one circle mirror it and draw two lines tangent to each circle all four spots and see. But everything must be black fully constrained. Did you stop sketch before push pull.
