Message 1 of 14
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
I'm trying to offset the outer perimeter of a face for an extruded cut. After completion it appears all is well, but there are a few tiny gaps in the sketch that prevent it from being a closed loop and allowing the extruded cut. Manually going to each small gap and closing them will not have the surfacing quality that I need, since there is curvature involved.
I have tried projecting the outer perimeter of the surface as a sketch and then offsetting that sketch, but the same issue occurs.
Is this a known issue?
Solved! Go to Solution.