Shelling Issue on an Angle

[jrobersonJE6HW]

I've been trying to shell a piece but when it shell it doesn't cut the angle but makes a straight edge. Is there a work around or something to fix this issue?

[jeff_strater]

can you share the model here?  Cannot tell from just an image.  Thanks.

[mango.freund]

why do you have interruptions here? are these bodies that are not connected? that could cause the problem. greetings mango

[jrobersonJE6HW]

Those aren't interuptions. Thats just the sketch being visible, as I wanted to show how I would've liked the shell to cut the piece. Which, as you can see on picture where I circled the angle being cut off and straightening instead of shelling continious angle.

[jrobersonJE6HW]

Here are some pictures

[TrippyLighting]

We need the model in .f3d format, not images of the model.

[jrobersonJE6HW]

AH! Okay. Here you go.

[WHolzwarth · Accepted solution]

There's a small vertical face between the red face and the internal bottom.

Delete it before the last shell, and it's ok. See section below.