transitioning from Solidworks to Fusion 360.
I'm trying to shell the body shown below.
no matter what thickness I try it fails. Overall I don't see that this shape is too complex. I created lofts, stitched them together to for the body below.
here is a link to the file.
No, this is not a very complicated structure but Fusion 360's shelling code is very sensitive to curvature problems and there is one area in the boat that has a problem.
However, even when that is fixed as shown in the 1'st screencast it's shelling this incredibly slow.
As mentioned in the 1st screencast I believe the lower part of the boat can be lofted in one go and actually would not need 2 different spline, however, if you do I=use 2 spins you need to make sure to use the proper sketch constraints to make sure they transition either tangent (G1) or curvature continuous (G2). This will make a tremendous difference in shelling performance as can be seen in screencast #2.
So in essence "mind your curvature"
https://knowledge.autodesk.com/community/screencast/6b869070-0baf-4b52-9850-b93502c81229
https://knowledge.autodesk.com/community/screencast/6b869070-0baf-4b52-9850-b93502c81229
