- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
I have tried to do some research through google and on the forum for this, but I cannot seem to figure out how to do what I want to do. First, due to the nature of the part, and its complexity, there is no way to sketch fillets and sweep the part to get rounded fillet corners. Second, *ideally* it would be nice if the fillets flowed into one another.
The example I have posted below is a quick mock up of the part just so you can see basically the issue. Instead of having a sharp edge at the meeting of the two fillets, I would like a rounded edge.
Solved! Go to Solution.