Passing an arc through a lign

[cesar.gironU5U5A]

Hello,

I use 3 points arc definition in a parametric model and i need that point to go over the segment composed by it's two extremities.

Here is an exemple of what i am looking to do with the parameter being 8-12. In that example i had to manualy redraw the arc cause the software doesnt allow the pass over.

Does someone have a solution or maybe a way around  (using conic or spline maybe) ?

Thanks in advance

[jeff_strater]

Yes, this is correct.  The Fusion sketch constraint/dimension system will not allow that arc to flip like that.  This is just a limitation of the system, so in this case, redrawing the arc is your only option, unfortunately.

Jeff

[cesar.gironU5U5A]

Well in that case gotta try to find a way around it.

If anyone hasan idea i was thinking working with conical curves which are not subject to this limitation....

Will let you know if i can find a way ^^ (at least approximate the closest i can)