Cheers / Ben
---------------------------------------------------------------------------------------------------------------------------
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
Check out my YouTube channel: Fusion 360: NewbiesPlus
Ben Korez
Fusion 360 NewbiesPlus
Fusion 360 Hardware Benchmark
| YouTube
Arcs are only approximate when zooming in. As @TrippyLighting says "Unfortunately". If Fusion 360 exposed the length and end point XYZ properties of lines and arcs it would make it much easier to verify coincidence. Currently the only way to tell if the line or arc is accurate is to use it until a failure occurs.
ETFrench
Ben Korez
Fusion 360 NewbiesPlus
Fusion 360 Hardware Benchmark
| YouTube
Perhaps I should have said any non-straight sketch item
Circles and arcs display the same behaviour.
ETFrench
