Importing SLDPRT, can't edit sketch.

Importing SLDPRT, can't edit sketch.

owarner5SRK2
Participant Participant
2,051 Views
2 Replies
Message 1 of 3

Importing SLDPRT, can't edit sketch.

owarner5SRK2
Participant
Participant

I am importing a SLDPRT file. I need to edit the dimensions, and I can't seem to be able to. I can edit the extrude feature, but not the simple sketch dimensions. Is this even possible?

0 Likes
Accepted solutions (1)
2,052 Views
2 Replies
Replies (2)
Message 2 of 3

JamieGilchrist
Autodesk
Autodesk
Accepted solution

Hi owarner5SRK2,

 

importing a SWX file translates just the 3D geometry of the model, it's essentially like a STEP file.  You can modify the geometry using the push/pull command, but you won't be able to edit it parametrically without rebuilding it in Fusion.

 

What are you looking to adjust?  There are a number of things you can do quickly, depending on your intent.

hope this helps,


Jamie Gilchrist
Senior Principal Experience Designer
0 Likes
Message 3 of 3

owarner5SRK2
Participant
Participant
Thanks for the reply. I figured as much. I needed to change the X and Y dimensions, and also the hole pattern on the model top. I did end up rebuilding it.