Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Importing Non-Linear Data below 0.001 GPa Young's Modulus
Importing Non-Linear Data below 0.001 GPa Young's Modulus
Hi,
In attempts to simulate different hydrogel behaviour (>0.001GPa) under static stress (compression), I have imported various stress vs strain curve graphs in the "advanced settings" options (compression data included). However, the software mentions that the data is out of limits. I've tried scaling all of the measurements as well as the force applied, however, the same error was the result. Any suggestions?
Fusion
