I created double body while I intend to create only one

[Anonymous]

I was sketching on a component that I had duplicated from similar component (but different component). Then I sketched on the face of the component. But what that I get is the new body is duplicated on the other component that is similar with the component which I sketched on the surface of that. I am a beginner of Fusion 360Note that the body that I created automatically have duplicates on the face of other component (which the component is duplicated from other component where I sketched on it), but it is definitely different component though

[davebYYPCU]

When you Copy  / Paste a Component, 

anything after that (new body) will happen in both components.

Copy / Paste New, will allow new parts to either component - that does not transfer over.

Might help....

[Anonymous]

Thank you, but can I fixed that without getting back to the beginning? i.e. I likely had my components copied not in 'New Paste' way. Is there other way to 'unlink' them?

[mavigogun]

---

@Anonymous wrote:

Thank you, but can I fixed that without getting back to the beginning? i.e. I likely had my components copied not in 'New Paste' way. Is there other way to 'unlink' them?

---

Maybe.   Sometimes I'm able to separate and capture work by Copying Components into another design, or another design without Capture of Design History enabled, then copy the product back as a unique Component.   Depending on the interconnections, Historied Components may bring Timeline error warnings, and those Dispensing with History may require later duplication of sans-History locked Sketch Elements.