Message 1 of 12
How to create this curve and adjust it?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
Hi,
I'm learning Fusion 360 and trying to create a simple trampoline spacer...it has a curved inner section.
I'm getting there...but am struggling with the easiest way to create the curved inner cut I need:
Specific struggles:
How do I create the inner arc cut? (Have tried creating an offset plane..then clumsily drawing a curve..)..but finding it a bit tough...
How do I set the dimension of the arc?
How do I repeat the arc symetrically on both sides?
How would you make this? Thanks so much. - MattHow do I cut this?