Help editing an imported .3DM file

[Anonymous]

Hi

I am trying to 3D print this piece downloaded from Thingiverse. ( http://www.thingiverse.com/thing:787994 )  Its the carriage to carry a camera, which runs on two guide rails, two linear bearings fit into the the two highlighted holes. The designer has kindly included the Rhino 3DM file. The problem I have is the diameter of my bearings is 1mm smaller than the printed hole and so are a very loose fit.

Is there anyway to make  the holes slightly smaller so they are a tight fit on the bearings? if so how best to do it?

thanks

[cekuhnen · Accepted solution]

@Anonymous for this task if the data is good you should be able to modify the sphere / cylinder radius with the solid modeling push command.

Works wonders in Fusion 360 to be honest!

[Anonymous]

Indeed that works and so simple, thanks for helping.

[cekuhnen]

@Anonymous Glad it worked. Fusion is amazingly good when editing solid models.