Getting errors when I use press pull command

[Anonymous]

Hello

I am trying to increase the thickness of this body by using the press/pull command but it keeps on giving me an error. What is the right way to increase the thickness of the part while maintaining it's profile

[Mike.Grau]

Hi @Anonymous,

Thank you for your post in the Forum.

Could you may share your design with us and create a screencast from your workflow?

If you would like to know how to:

• Share the design via "Public Link", please review the article Here shows
• Download Screencast for your Operating System, please use this article Here
• Create a Screencast to share a video of your workflow with the link Link Here

I hope this information helps. Please, keep me updated.

Thanks,

[Anonymous]

Hi Mike,

Here is the public link for my part (http://a360.co/2jLsdIW), as for the screencast, I'm a newbie and would prefer if perhaps you can screencast the "right" way to do it so that I learn from an expert. I hope thats acceptable.

Thanks,

Mike

[Mike.Grau]

Hi @Anonymous,

Thank you for sharing your design.

I have been able to use press/pull to increase the thickness of your design.

Just noticed that this might uses a bit of computational and graphics resources.

Here is the design and a screencast: http://a360.co/2jOrma4

Please, let me know if this is what you have been looking for.

If this doesn´t work on your computer, we might need to check your hardware and drivers.

Thanks,