Fusion 360 Offset Issue

[drkwownerd]

Whenever I go to offset my 3 and D the offset does not go around the entire number/letter. I don't see any breaks in the border and therefore cannot offset it properly to extrude.

[Bunga777]

I think it depends on the font and you should attach the data where this condition occurred.

[drkwownerd · Accepted solution]

Managed to sort it, had to trim and redraw some of the letter.

[fay225]

I'm in the same boat. How do you find out where you have the break or problem in the perimeter?

[TrippyLighting]

Create a new thread, share your model/file in .f3d format.