Fillet only half of a line

[Anonymous]

Hey,

I am trying to make my design a little sleeker. I am playing with a standard extruded rectangle 6x3x3. Is there a way to break up the line essentially add a point so I can only Fillet the first 3 inches of the 6 inch length of the line.  Also any other good touch up tools besides fillet that you would recommend.

I have already attempted to go back into the edit sketch to add lines/points and it didn't work.

[I_Forge_KC · Accepted solution]

You can do variable fillets like this...

Is that what you're looking for?

[Anonymous]

Hey,

I would like to make everything outside of the hole perimeter concave (the shaded part and below the blue). If I can make it a smooth transition that would be even better. I did not use the sculpt I know its very easy in that form. But I would like to do this with sketch compatibility. overall shape is a long rectangle

 

[TheCADWhisperer]

---

@Anonymous wrote:

.... (the shaded part and below the blue). 

 

---

What is the significance if the image with red?  You give information about below blue, but no information about red?

Can you File>Export your *.f3d file to your local drive and then Attach it here to a Reply?

[Anonymous]

Hey,

I am trying to make it concave like this that I made in sculpt but in sketch. This would represent the blue line. The Red shaded part was a more complex concave what I was trying to concave