Design issue

[Anonymous]

Hello All,

I'm a beginner in Fusion 360 and I'm facing some issues while designing water dispenser. I'll be extremely thankful if you can help me out with my design. 

I have attached the images for your reference. I'm unable to flatten the tip of the Water dispenser Pencil. Kindly help me out with this.

Awaiting for your reply.

[lichtzeichenanlage · Accepted solution]

1. Create an offset plan from the bottom at that height you want to cut
2. Use that new plane in "Modify -> Split Body" to cut the tip
3. Right click the top in the browser and use remove to eliminate that part you don't want to keep

[jasonhomrighaus · Accepted solution]

Create your pencil then create a drawing on the end of it, in this case a triangle, then extrude the triangle and set the taper angle to a negative number that fits your design, then use split body and the pencil shaft to trim the edges,

[Anonymous]

Thanks a lot 🙂