Crash and loss of work

[jeffescott]

So working along then the body changed from a solid to an outline....

Clicked back and forth on visibility in the browser...

The body cam back to a solid rather than an outline.

Then it switched back to an outline..... clicking back and forth did not help also tried apperance did not help

I was unable to get the extrude i was working on to recognize the body to cut it.

Then fusion crashed

crash report 701170836

So now what happens i have reopened the file (lost 3 hours of work yes should have saved more often) 

But body remains as an outline  

[g-andresen · Accepted solution]

Hi,

If you mean body 6, it is in the primary level, but it is hidden by body 11 in the "Nylon Base" component.

günther

[jeffescott]

im sorry guenther for some reason I dont get any sound so it is tough to follow...

I did manage to get body 19 to show but again only with outline....

I have made some updates so I will reattach the file

any idea why know sound???

[jeffescott]

finally found it some how the display had toggled to wire frame only????

Now I just hafta figure out why i don,t get sound on your video

[g-andresen]

Hi,

---

@jeffescott  schrieb:

Now I just hafta figure out why i don,t get sound on your video

---

Because there is none.

günther

[g-andresen · Accepted solution]

Hi,

I took another look at the situation.
Obviously, there is a priority for opacity control.
Here, the primary layer setting overrides the settings in the assemblies.
That means, if an opacity of 100% is set for the assembly, it will only take effect when the assembly is activated.
However, if the primary layer is active (all assemblies), the opacity setting of the primary layer will take effect.
I have not noticed this effect before.

günther

[jeffescott]

Ill work through this.  Thx alot for all your time