Connecting faces of different sketches to create a curved triangle pyramid

[Anonymous]

Note: i dont know if there are similar questions of this because i dont know how to word this question at all.

Note: This is also not the same as the topic "Pyramid with curved sides"

So i want to connect these faces to create a body. What i want in the end is somewhat of a triangle pyramid made out of those 3 faces. However, these aren't triangles, because the faces are made out of lines with conic curves of 0.75 rho value.

Those highlighted faces will eventually make a "triangle pyramid" but with an increasing base length

[TheCADWhisperer · Accepted solution]

Does Loft to Point (with guide curves) work?

Can you File>Export and then Attach your *.f3d file here?

[lichtzeichenanlage · Accepted solution]

Nice design. Next time you might want to reduce your sketch effort and just implement one spike and than pattern it. Just a thought...

[Anonymous]

Thanks for the reply! 

No, i tried loft and it doesnt work. I didnt expect loft to go to a specific point lol. Anyways, here is what happens:

Without guide rails:

With attempted guide rails:

NOTE THE SAME 

THING HAPPENS WHEN I TRY TO SWEEP IT UP AND USE GUIDE RAILS

[Anonymous]

What if i try connecting the curved lines to create faces? then i can do boundary fill. But then the lines are on different sketches and different planes....

[TheCADWhisperer · Accepted solution]

Why did you mark it as Solved if it isn't solved?

You have all sorts of issues in your Timeline.

File>Export and then Attach your *.f3d file here and end all doubt.

[lichtzeichenanlage · Accepted solution]

Can you share the design? Perhaps you might be able to use loft + rails