Components priority view

[PLAmenPRINT]

Hello,

I am trying to design a speaker box and so far I have created two components - The box and the speaker.

(samples below)

At this moment I don't know big and where the hole will be but I would like to make kind of assembly.

The question: Is there a way to give a view priority to a particular component in order to have it on top of other but not as the image below? Is it possible a component cut on place?

Thanks

Regards

[PLAmenPRINT]

Hello,

I am trying to design a speaker box and so far I have created two components - The box and the speaker.

(samples below)

At this moment I don't know big and where the hole will be but I would like to make kind of assembly.

The question: Is there a way to give a view priority to a particular component in order to have it on top of other but not as the image below? Is it possible a component cut on place?

Thanks

Regards

[g-andresen]

Hi,

Please share the file then your questions can be addressed more specifically.

File > export > save as f3d on local drive  > attach it to the next post.

günther

[g-andresen]

Hi,

Please share the file then your questions can be addressed more specifically.

File > export > save as f3d on local drive  > attach it to the next post.

günther

[PLAmenPRINT]

Here attached is the file.

Just to mention that this is just a sample and the shapes are not important.

The point is to have clear view of the green component (speaker) but not intersected as now.

Thanks

[PLAmenPRINT]

Here attached is the file.

Just to mention that this is just a sample and the shapes are not important.

The point is to have clear view of the green component (speaker) but not intersected as now.

Thanks

[g-andresen · Accepted solution]

Hi,

Maybe this screencast will help you?

günther

[g-andresen · Accepted solution]

Hi,

Maybe this screencast will help you?

günther

[PLAmenPRINT]

Thanks for the solution.
Is the cut going to move together with the component if I need to move or rotate it?

[PLAmenPRINT]

Thanks for the solution.
Is the cut going to move together with the component if I need to move or rotate it?

[g-andresen · Accepted solution]

Hi,

Since the positioning (joint) is done before combining/cutting, the cutout in the box is also adjusted when changes are made.

günther

[g-andresen · Accepted solution]

Hi,

Since the positioning (joint) is done before combining/cutting, the cutout in the box is also adjusted when changes are made.

günther